CoreHog™
Speeds and feeds for aramid core honeycomb tools.
  • Above listed speeds and feeds subject
    to variation from different treatment process, fixturing, etc.
  • If cut face of material appears to be getting too hot, increase feed rates
    or drop spindle RPM
  • If material tearing occurs at cells, decrease depth of cut and/or step over distance rather than plunging if possible when pocketing or roughing
  • 15 degree ramp angle is desirable
  • Conventional cutting is recommended for the slicer combination tools whenever possible but is not necessary
    if climb milling is required
  • Cut direction is not important when using CoreHog™ carbide roughing tools. Ramping into material is recommended
  • Listed speeds and feeds are to be used as a general guideline; adjustment may be necessary on a case-by-case basis

Call for specific technical questions

Speeds and Feeds
for Aramid Core Honeycomb Tools

Technical Resources

Cutter Size/Type Depth of Cut Stepover Spindle RPM Feedrate (IPM) Info
.250" Corehog Rougher
(25CH / 25BACH
.250"–.500″ 0.125" 18000 – 24000 350 – 600 IPM Decrease depth of cut on lighter density
core to reduce possibility of cell fracture
.500" Corehog Rougher
(5CH / 5BACH)
.250" .250" 18000 – 24000 1000 – 2000 IPM Decrease depth of cut on lighter density
core to reduce possibility of cell fracture
1.0" Corehog Rougher
(1CH / 1BACH)
.250"–1.00" .500"–1.00" 18000 – 24000 1000 – 2000 IPM Decrease depth of cut on lighter density
core to reduce possibility of cell fracture
45 CSHA
(Full Assembly)
.600 Rough
.150 Finish
.89 Rough
.250 Finish
18000 – 24000 600 IPM .600 Doc for roughing
.05" – .150" DOC finish
1/2° – 5° lead angle
63 CSHA
(Full Assembly)
.600 Rough
.150 Finish
1.24 Rough
.250 Finish
14000 – 16000 600 IPM .600 Doc for roughing
.05" – .150" DOC finish
1/2° – 5° lead angle
2 CSHA (Long)
(Full Assembly)
1.375 Rough
.150 Finish
1.0 Rough
.250 Finish
15000 – 18000 600 IPM 1.375 Doc for roughing
.05" – .150" DOC finish
1/2° – 5° lead angle
.500" CoreSlicer
(5CSH)
.050" Finish .150" Rough
.04" Finish
18000 – 24000 50 – 80 IPM .025" – .150" depth for finishing
1/2° – 3° lead angle
Designed for corner cleanout in pockets and fine detailing work
10mm Coreslicer
(10mcsh)
.025" Finish .035 – .075" 18000 – 24000 80 – 100 IPM .050" – .150" depth for finishing
1/2° – 3° lead angle
Designed for corner cleanout in pockets and fine detailing work
Efficient customer service information

Get in Touch with CoreHog™

You will always find a courteous staff ready to answer your questions at CoreHog™. We take pride in
our customer service and efficiency. 661-467-0440

Learn more about how you can improve your milling process while saving money.

request@corehog.com

Aramid core

Aramid Core

 

© COPYRIGHT 2015 COREHOG™ | DISCLAIMER

CoreHog™ logo